Drilling at each rib location along the forward spar first followed by fore to aft rib rivet hole with #40 bit.
posted by Unknown at 9:23 AM
Friday, June 29, 2007
Previous Posts
- Position and drill the upper skin.
- Here, the retainer clip was positioned and drilled...
- The four pre-punched locations on the right hand s...
- I have switched to 90 degrees angle drilling using...
- After drilling at marked loactions with #30 bit.
- I got confused with the orientation of the left/ri...
- Close up view of the trim tab pushrod after cutt...
- Guess what i finally found the missing Dremel cutt...
- Having "final" drilled the #40 rivet holes with #3...
- Yet another mistake..guess if i had cut the trim t...
0 Comments:
Post a Comment
<< Home