Mark and cut the tip rib notches in the lower left and right skins.
posted by Unknown at 8:37 AM
Friday, June 29, 2007
Previous Posts
- Here, Rib C and D were shown with the outboard rib...
- After drilling all spar/rib holes with #30 bit.
- Close up view of #30 holes drilled.
- Drill and Cleco the ribs to the forward spar.
- Fabricating the trim cable retainer clip.First dri...
- Pre-assemble all the ribs on to the forward and af...
- and the forward spar as well..
- Note, i did not follow the manual strictly coz i...
- Drilling the four pre-marked locations with #30 bit.
- Clamping the forward gate, left bracket angle, lef...
0 Comments:
Post a Comment
<< Home