Drilling the four pre-marked locations with
#30 bit.
#30 bit.
posted by Unknown at 8:19 AM
Friday, June 29, 2007
Previous Posts
- Clamping the forward gate, left bracket angle, lef...
- Tadaaah..
- Next, clamp together the left and right bracket an...
- Fabricating the forward gate. Pre-marked and lig...
- Snip..snip..snip...out come the forward gate, left...
- Trimming off attach angles with my Dremel cutter.
- After drilling the six holes..
- Stack up both control horns and their respective a...
- Clamp the two horns together with side grips and...
- Re-clamping them with their other flanges together...
0 Comments:
Post a Comment
<< Home