Note, only the four pre-punched holes over Ribs A and B are drilled for the moment. Here, i drilled the aft spar with #40 bit.
posted by Unknown at 8:45 AM
Friday, June 29, 2007
Previous Posts
- Drill the first three rib holes with #40 bits coun...
- Drill the remaining spar and rib holes.
- Positioning the lower right skin and drilling at t...
- Mark and cut the tip rib notches in the lower left...
- Both Ribs C and D were positioned bback with a pai...
- Here, Rib C and D were shown with the outboard rib...
- After drilling all spar/rib holes with #30 bit.
- Close up view of #30 holes drilled.
- Drill and Cleco the ribs to the forward spar.
0 Comments:
Post a Comment
<< Home